RF-Max Digimax 210 Guide de l'utilisateur

Digimax 210Programmable ThermostatUser Guide

4. Trouble shootingIf the heater does not operate when the thermostat isasking for warm, check the battery indicator and changesthe battery units if n

The RF DigiMax 210 thermostat does not need any extrawiring and works within 30 meters range around the receiverRF-Max. The DigiMax 210 is equiped of

III. Installation :Please read all installation instructions before proceeding.The RF DigiMax 210 works with batteries. It does not needany wire. If y

1 Open the unit by slackening the retaining screw situated inthe bottom edge and hinging carefully upwards. Disen-gage the unit from the wall-plate an

4 Replace batteries being sure to observe the correctpolarities. Re-fit to plastic base and tighten retaining screw.Check unit is functioning as requi

RF DigiMax 210 Rear ViewCut Link 1 for 16°C minimum set pointCut Link 2 to display cooling symbolinstead of heating symbolBatteriesLink 2Link 13 2

RF Receiver Led’s (indicators) :Red Led :‘flashing’ : indicates receiving an RF signal‘steady on’ : indicates a fault condition e.g. RF signalnot bein

2. Within the 5 minute install period go to the RF-Max Re-ceiver. Press and hold the Install button and then pressthe Test button while the Install bu

utes the Red LED will flash for 3 seconds. If the RF-Maxdoes not receive regular RF signals the Red LED willcome full on indicating that a fault condi